Add more inputs and outputs to your Microbric robotics creation with the Microbric Modules Panel. This panel also includes some blank modules such as right angle and straight modules, so you can further customise your robot kit.

The Microbric Modules Panel includes:

	2 x bump sensor module Additional parts such as a bump sensor retainer, bump sensor insert and bump sensor elastomer are required to build a complete bump sensor. These parts can be found in the Strut Panel and Hardware Pack.
	2 x Right angle modules Note that the two right angle modules are opposite facing (i.e. One turns to the right and the other turns to the left).
	4 x Straight modules These are blank modules that can be used to extent input & output modules or even be hacked to become a module of your own design!
	2 x LED Modules  These LED modules illuminate red and are much brighter than the LEDs on the Microbot motherboard.
	1 x Switch module The switch module outputs either a high (1) or a low (0). You can use the switch module to set modes in your robot's program (i.e. if the switch is set to 1 - be a line following robot, if set to 0 - be a bump robot)
	1 x Buzzer module The buzzer module is fitted with its own volume control, so you can control how loud it is by turning it up or down. Great for those late night project when you don't want to keep the whole house up!
	1 x IR receiver module Receive commands from a standard TV/DVD remote control or from the Microbric remote control.
	1 x Button module The button module sends a high (1) when pressed.